1999 Volvo Penta "WT" Models Workshop Manual, Page 364Get this manual
[]]3Install forward engine mount lag screws and tighten them securely 3.0 Models
All V6 and VS Models] ]
If vertical drive was not removed, go on to Exhaust Hose AttachmentIf vertical drive was removed, continue with Engine Alignment section
Engine Alignment
Correct engine alignment is essential to long engine drivetrain lifeThe front engine mounts may need adjustment UP or DOWN to produce correct engine alignmentUse Alignment Tool, Volvo Penta PiN 3851083-0, or OIVIC PiN 912273, with Universal Handle, Volvo Penta PiN 3850609-3, or OIVIC PiN 311880, to check engine alignment
[] 1Slide alignment tool through driveshaft gimbal bearing CDThe alignment tool must slide through the gimbal bearing and into engine coupler with easeIf the alignment tool binds going into engine coupler, make sure the gimbal bearing is properly alignedIf gimbal bearing alignment is correct, the front engine mounts must be adjusted either UP or DOWN, as required, until alignment tool slides easily in and out of engine coupler