1999 Volvo Penta "WT" Models Workshop Manual, Page 312Get this manual
m 5Remove cotter pins and loosen both anchor screws until steering cylinder assembly can be removed
Cylinder Servicing 1Pry out steering pivot bushings if they are to be replacedIf necessary they may be carefully drilled in two places with 116 in(1,5 mm) drill bit and then removed2New bushings should be lubricated and pushed into place
3The cylinder rod should be wrapped with heavy paper or pasteboard and held in vise with Rod Holder, Volvo Penta PiN 3854367-4, or 0fVIC PiN 983213 To remove the clevisunscrew the 19 mm locknut 23-28 4To reinstall clevis, tighten piston rod locknut Ibs(31-38 Nm)
Cylinder Installation 1Install anchor screws bracket
flush with
inside of inner transom