1999 Volvo Penta "WT" Models Workshop Manual, Page 188Get this manual

1999 Volvo Penta "WT" Models Workshop Manual, Page 188

Installation Tool Required: 39046 Crankshaft Balancer Installer

Install or connect:

The inertial weight section of the crankshaft balancer is assembled to the hub with rubber type materialThe correct installation procedures (with the proper tool) must be followed or movement of the inertial weight section of the hub will destroy the tuning of the crankshaft balancer1Use small amount of RTV sealant to seal the balancer keyway to crankshaft jointDRC6671

Back to 1999 Volvo Penta "WT" Models Workshop Manual