1999 Volvo Penta "WT" Models Workshop Manual, Page 112Get this manual
m 2assemblybolts from engine bracket and remove rubber Remove two mount 3Remove lower nut and washer on shaft and remove shaft from lower mount[] 4Upon complete disassembly, check pieces and replace where necessaryReassembly
1Place one nut and washer on trim shaft, then set trim adjustment shaft in lower mountInstall remaining washer, and screw on lower nutMake sure at least three shaft threads extend through nutTighten nuts finger tight, do not tighten at this time
[] 2Place engine bracket spacer on shaft
3Attach rubber mount to engine bracket with two bolts and tighten to 30-35 ftIbs(41-47 Nm)4Place engine bracket assembly on shaft with large and small washer and tighten nut to 50-60 ftIbs(68-81 Nm)