1999 Volvo Penta "WT" Models Workshop Manual, Page 108Get this manual
6Place bushing and driver on block and drive the bushing in positionDepth is determined by tool bottoming against the block
7Remove tool from bushingIt is possible that the bushing with minimum I.Dwill collapse enough, during installation, to slightly seize the installer arborIf this happens, remove installer tool uSlng slide hammer in driver bolt hole of driver handle
INote This will not damage the bushing and the tool is designed
for this purpose, should it occur
Circulating Pump
Removal
1Remove drain plugs on port side and drain coolant from block and exhaust manifoldDisconnect water hose from circulating pump2Loosen four screws holding circu lating pump pulley to circulatIng pump3Loosen alternator bracket bolts and remove alternator beltRemove circulating pump pulley and boltsUnscrew bolts and remove the circulating pump from the engine
INote Pull