1999 Volvo Penta "WT" Models Workshop Manual, Page 89Get this manual
Timing Gear Cover Installation 1Clean gasket surface on block and cover2Install centering tool J-35468 over end of crankshaft 3Coat both sides of new gasket with light grease, and stick gasket in position on block [j]
4Place cover over centering tool and install cover screwsTighten screws to 27-35 inIbs(3-4 Nm) and remove centering tool5Install oil pan using new gasketsTighten rear oil pan nuts to 165 in.lbs(18,6 Nm), crankcase screws to 80 in.lbs(9 Nm), and front cover screws to 45 in Ibs(5 Nm)6Connect oil drain tube to oil panHarmonic Balancer Installation
m 1.Position hub over crankshaft harmonic and start with Coat oil seal contact area on balancer engine oiland key, hub