1999 Volvo Penta "WT" Models Workshop Manual, Page 27Get this manual

1999 Volvo Penta "WT" Models Workshop Manual, Page 27

Preparation for Boating After Storage 1Install all drain plugsInstall cooling hoses and clampsCheck condition of hoses, manifold end caps and clampsConnect hoses to engine and tighten clamps securelyInstall boat drain

plug, if removed2Remove the distributor cap and rotorWipe the inside of the distributor cap dry with clean cloth and spray with DuraPlus ,',','

Corrosion Spray or CX'JIC OPL Penetrating LubricantReplace the
rotor and cap3Clean the battery terminalsWith the ignition switch in the

"OFF" position, install the battery and attach the battery cablesSpray terminals with DuraPlus T," Corrosion Spray or OIVIC Anti-

Corrosion Spray
4Open the fuel shut-off valve (if so equipped) and check all

Back to 1999 Volvo Penta "WT" Models Workshop Manual