1999-2001 Yamaha Phazer 500 / Venture 500 service manual, Page 342Get this manual
CABLE ROUTING 1 Make sure that the oil tank cap and oil tank breather hose do not touch each other2 Route the fuel tank breather hose along the side of the frame3 Route the oil tank breather hose along the side of the frame4 Install the tailbrake light lead behind the instrument panel5 Pass the tailbrake light lead through the inside of the tab on the frameRoute the tailbrake light lead in front of the tab on the frame6 Fasten the oil tank breather hose, fuel tank breather hose and wire harness at the inside of the instrument panel screw with plastic band7 Route the tailbrake light lead between the fuel tank and the snowmobile bodyMake sure that the fuel tank does not crush the tailbrake light leadThen, fasten the three pieces of adhesive tape below the fuel tank as shown8 Adhesive tapes 50 mm (1.97 in)70 mm (2.76 in)To the tailbrake light Pass the wire harness and fuel tank breather hose through the cable holderB Install the metal clip facing upward and downward