2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 827Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 827

Section 02 ENGINE Subsection 09 (CYLINDER BLOCK)

4In sta ll crankshaft
2Remove balancer shaft
RlDitil If the oil spray nozzle is damaged, it

must be replacedRefer to LUBRICATION SYSTEM subsection5Properly reinstall crankshaft thrust washers with the slots facing against crankshaft counterweights
NOTE: Th rust washers have to be flush with the cylinder block sea ling surface .111I t

1Balancer shaft

Balancer Shaft Inspection
Check each bearing journal of balancer shaft for scoring, scuffing, cracks or other signs of wearCheck if balancer shaft gears are worn or otherwise damaged
A I!,03mut It

TYPICAL 1Thrus washer 2Sealing surface

6Install connecti ng rod caps Refer to PISTONS AND CONNECTING RODS in this subsection
1Balancer gear 2Water pump dfl ve gear