2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 824Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 824

Section 02 ENGINE Subsection 09 (CYLINDER BLOCK)

NOTE: Before continuing the assembly process, the axial clearance of balancer shaft and crankshaft has to be checked Refer to CRANKSHAFT and BALANCER SHAFT in this subsection for the procedure8Reassemble engine in accordance ith the proper assemb ly procedures
4Install the dial indicator in spark plug hole of cylinder no2
CRANKSHAFT
Crankshaft Locking Procedure

,tt1iljl The crankshaft must be locked at TDC for removal and installation work on crankshaft, balancer shaft and camshaftNOTE: When the crankshaft is locked, the piston of cylinder no2 is at overlapping TDCCrankshaft can be not locked at cylinder no and no3 TDC 1Remove the valve coverRefer to CYLINDER HEAD subsection 2Remove spark plugs3Remove the tip at the end of the TDC DIAL INDICATOR (PIN 414 104 700) and install the DIAL