2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 819Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 819

Section 02 ENGINE Subsection 09 (CYLINDER BLOCK)

11 Remove plug screw to get access to M8 cylinder block screw

14Remove connecting rod caps Refer to PISTONS ND CONNECTING RODS1Remove plug screw 2M8 ylinder block sCl ew

15Remove balancer shaft and crankshaftSee proced ure in this subsection 16Remove crankshaft thrust washers 17Remove pistons and connecting rodsSee procedure in this subsection
NOTE: Before splitting the cylinder block, measure crankshaft and balancer shaft axial playRefer to CRANKSHAFT and BALANCER SHAFT in this subsection 12 Remove cylinder block screws
Plain Bearing Removal
Wh en the plain bearings need to be removed from the cylinder block, mark them to identify the correct position at installationSee the following illu stration for an example1Mark on balancer shafr plain bearings 2Mark on crankshaft plain bearings