2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 817Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 817

Section 02 ENGINE Subsection 09 (CYLINDER BLOCK)
PTG Cover Inspection
Check the PTO cover for cracks or other damagesCheck the sealing surface for flatness using straight edgeInspect ball bearing for excessive play and smooth operation Replace damaged parts
1Suitable pusher

2PTO cover
3Straight support

4 Discard the ball bearing
Bearing Installation

m,j'ljj Never

Bearing Replacement (PTG Cover)
Bearing Removal
1Unscrew flat head screw, securing ba ll bearing in place
reinstall ball bearing that has been removedUnless otherwise in structed, never use hammer to install ball bearingsUse press only1Support the PTO cover with suitable support underneath the bearing seat

2Carefu lly press-in the NEW ba ll bearing from
the inside towards the outside by using suitable steel tube with an outer diameter of 76 mm (2 .992 in)