2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 815Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 815

Section 02 ENGINE Subsection 09 (CYLINDER BLOCK)

GENERAL
When disassembling parts that are duplicated in the engine, (e .g pistons, connecting rods etcit is strongly recommended to note their position (cylinder 1, or 3) and to keep them as "group" If you find defective component, it wou ld be much easier to find the cause of the failure within the group of parts Besides, since used parts have matched together during the engine operation, they il keep their matched fit hen you reassemble them together ithin their" group" Even though many parts do not need to be removed to reach other parts, it is recommended to remove these parts anyway in order to check them During assemb lyinstallation, use torque val ues and service products as in he exploded viewClean threads before applying thread lockerRefer to SELF-LOCKING FASTENERS and LOCTITE APPLlCATIONat the beginning of this manual for complete procedure
3Crankshaft axial play out of specification- Measure crankshaft axial playIf crankshaft axial plav is out of specification, replace thrust washers