2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 799Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 799

Section 02 ENGINE Subsection 08 (CYLINDER HEAD)

1Adjus tmen shims are

8Carefully reinstall camshafts as follows 8.1 Move camshafts to thei final position 2LocKmg Ie over cam followers

Lockmg tie between c8mshaft and its holder no3

3Lockmg tie between cam follower and holder no4

8.2 Check if all shims and all cam fol lowers are in place
NOTE: If two locking ties must be used to attach one side, make sure both attachment ends are on the top side of camshafts
1Cam followers position over shims

1Locking tie mstalled without Joint

8.3 Instal loosely all camshaft holders