2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 778Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 778

Section 02 ENGINE Subsection 06 (MAGNETO AND STARTER)
4Remove the thermostatRefer to COOLING SYS TEM subsection 5Remove retai ning screw from intake man ifold support
I Clean mating surfaces

2Apply SUPER LUBE GREASE (PIN 293 550 030) on the starter O-ring and LOCTITE 767 (ANTISE IZE LUBRICANT) (PIN 293 800 07 0) on starter gear before insta llation
2Intake mandold support

1Remove screw

6Remove the starter cable from starter7Remove starter retaining screw and intake manifold support
2ApplV antiseize Ilibricant

1ApplV super lube grease

3Install starter screws wit the air intake man ifold support4Tighten screws to 11 (97 Ibfin)flU1II 1001"'109 II