2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 777Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 777

Section 02 ENGINE Subsection 06 (MAGNETO AND STARTER)

3Install probes of the FLUKE 115 DIG ITAL MULTIMETER (PIN 529035 868) on battery posts
RED (+i handle Slaner cable Groul1d cable BLACK (0) handle

If starter now turns ensure the cable and connections from battery to starter solenoid are in good conditionIf they test good, the starter solenoid can be suspected Refer to STARTING SYSTEM subsection- If starter so lenoid test good, perform the STARTER VOLTAGE DROP TEST (AT BA TTERYJA problem with the starter armature is possibleIf starter does not turn, check the starter cable and connectionsIf good, check for mechanical problems in the starter
4Crank engine by installing fused jumper wire between the negative post of battery and the ORANG EBLACK ire on starter so lenoid
Starter Voltage Drop Test (At Battery)
NOTE: This test will confi rm if starter draws too much currentBattery must be fully charged and in good cond ition 1Fused Jumper wire