2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 772Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 772

Section 02 ENGINE Subsection 06 (MAGNETO AND STARTER)
If any voltage reading is lower than specification, replace the stator
Stator Removal 1Remove the MAGNETO COVER,
dure in this subsection 2Remove stator reta ining screws
see proce-

2Read resistanceSTATOR INSULATION TEST

PROBE POSITIONS Any YELLOW wire and chassis ground

RESISTANCE 20C Infinity (OL)

If an resistance reading is not as specif ied, he stator or the wiring is shorted to ground and needs to be repaired or replaced If the insulation test is good, perform the output voltage testI Ststor Ststor retaining screws

Stator Output Voltage Test
1Reconnect the magneto connector2Connect battery and start engine Let engine reach its operating temperature 3Set multimeter to Vac sca le4 Connect multimeter between each pair of YELLOW ires