2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 769Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 769

Section 02 ENGINE Subsection 06 (MAGNETO AND STARTER)
GENERAL

The engine removal is necessary to work on the magneto systemDuring assemblyinstallationuse the torque values and service products as in the exploded viewClean threads before applying threadlockerRefer to SELF-LOCKING FASTENERS and LOCTITE APPLlCATlONat the beg inning of this manual for complete procedure1Remove screw 2Cable clamp

WARNING

5Remove CPS sensor wire from both cable clamps
Torque wrench tightening specifications must strictly be adhered toLocking devices (ex: locking tabs, elastic stop nuts, self-locking fasteners, cotter pin, etc must be replaced with new onesHosescables or locking ties removed during procedure must be reinstalled as per factory standards