2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 752Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 752

Section 02 ENGINE Subsection 05 (COOLING SYSTEM)
GENERAL
For better understanding, some illustrations are take ith engine out of vehicle NOTE: It is good practice to check for fau lt codes using B.U.D .Ssoftware as first troubleshooting step Refer to the MONITORING SYSTEM ND FAULT CODES subsection During assemblyinstal lation, use the torque values and servi ce products as in the exploded view sClean threads before applying threadloc kerRefer to SELF-LOCKING FASTENERS and LOCTITE APPLICATlON at the beginning of this manual for complete procedure
2Place large drain pan under the vehicl bottom pan 3Unplug the drain plug screw at water pump to drain coolant
WARNING

111-111,';:'" I

Torque wrench tightening specifications must strictly be adhered toLocking devices (e.g locking tabs, elastic stop nuts, cotter pin, etc must be replaced with new onesHoses, cables or locking ties removed during procedure must be reinstalled as per factory standards
UNDER EXHAUST MANIFOLD Drain plug screw 2Water pump