2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 744Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 744

Section 02 ENGINE Subsection 04 (LUBRICATION SYSTEM)
Clean engine oil strainer with part clea ner then use an air gun to dry itCheck engine oil strainer for damage and replace if necessary
Oil Suction Pump Installation
For installationreverse the removal procedureHowever, pay attention to the following detailsInstall oil strainerCoat inner and outer rotors with eng ine oilInstall oi pump shaft ith small oi suction pump rotors into its bore in the cylinder block
II Il OO!}' 11001 .6

1Oil pump cover 2Oil pump sha ft 3Needle pin 4Inner roror 5Outer rotor

6Remove and discard the oi pump cover O-ring
1Oil pump shaft WIth small or! suctIon pump