2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 716Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 716

Section 02 ENGINE Subsection 02 (AIR INTAKE SYSTEM)
GENERAL
During assemblyinsta llat ion, use the torque values and service products as in the exploded viewClean threads before applying threadlockerRefer to SELF-LOCKIN FASTENERS and LOCTITE APPLICATION at the beg in nin of th is man ual for comp lete procedure
Air Filter Cleaning
Clean ith fresh ater and mild soa pReplace air filter as required NOTE: If the filter is very dirty, clean the interior of air in take silencer at the same time
Air Filter Installation
The installation is the reverse of the remova procedure
WARNING

Torque wrench tightening specifications must be strictly adhered to Locking devices (e.g: locking tabs, elastic stop nuts, cotter pins, etc must be replaced with new onesHoses or cables removed or disconnected mu st be instal led and routed at he same place
INTAKE MANIFOLD
Intake Manifold Removal
1Remove fu el tank Refer to FUEL TA NK AND FUEL PUM subsection 2Cut locking tie of id le air control valve (IACV) connector3Unplug from intake man ifold3.1 Manifold abso lute pressure and tempe ratu re sensor (MAPTS) 3.2 Idle air control valve (IACV)