2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 714Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 714

Section 02 ENGINE Subsection 01 (ENGINE REMOVAL AND INSTALLATION)

ENGINE RUBBER MOUNT
Engine Rubber Mount Inspection
Check rubber mountsReplace them if brittlecracked or damaged
Engine Rubber Mount Removal
NOTE: Remove the exhaust manifold and insta ll the ENGIN LI FTING TOOL (PIN 529 036 151) before beginning th engi ne rubber mount removal procedure rwm 4'tX'l' !vb 0-43.0

1Engme rubber mount 2Retammg screws

4Remove the engine rubber mount
MAG Side Rear Engine Rubber Mount
1Remove engi ne from vehicleRefer to ENGINE REMOVAL in this subsection2Remove and discard both engine rubber mount screw s
PTO Side Engine Rubber Mounts The engine rubber mounts located on the brace are not available separatelyReplace th brace wh en an engine rubber mount must be replaced Refer to PTO SIDE BRACEin FRAME subsection MAG Side Front Engine Rubber Mount