2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 698Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 698

Section 01 MAINTENANCE Subsection 02 (STORAGE PROCEDURE)
DRIVE SYSTEM AND BRAKE
Brake Lever
Remove the brake lever pivot and apply XP-S SYN THETIC GREASE (PIN 293 550 010) on itReinstall pivot and tighten its nut to N- (53Ibf-in)
Steering Mechan ism
Inspect all components for tightn ess
Skis and Runners
Inspect skis and runners for wear, deterioration or damage, replace if necessary
Drive and Driven Pulleys
1Remove drive be lt2Inspect and clean pulleys3Spray XP-S LUBE (PIN 293 600016) on sheaves to protect them from rust4Do not reinstall drive be lt
VEHICLE
Vehicle Cleaning
Keep eng ine compartment clean of grass, twigs, cloth, etcThese are combustib le under certain conditions To clean the veh icle, do not use high pressure washers (like the ones found in car washes) as it may damage certain parts of the vehic leTo clean the vehicle, proceed as fo llows1Rinse the vehicle thorough ly with water to remove loose dirt2Using soft clean cloth, wash the vehicle ith ate mixed with mild detergent, such as soap specially formu lated for motorcycles or automobi les 3Wh ile washing the vehic le, check for grease or oilIf necessary, use BRP PLASTICVINYL CLEANER (PIN 413 711 200) or mild automotive degreaserFollow thoroughly the manufacturer's instructions