2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 687Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 687

INTRODUCTION
CASE-IN COMPONENTS
Metallic Gaskets

moilil Most components of those vehicles

are built with parts dimensioned in the metric systemMost fasteners are metric and must not be replaced by customary fasteners or vice-versaMismatched or incorrect fasteners could cause damage to the vehicle or possible personal injuryAs many of the procedures in this manual are in terrelated, we suggest, that before undertaking any task, you read and thoroughly understand the entire section or subsection in which the procedure is containedA number of procedures throughout the book require the use of special toolsBefore commencing any procedure, be sure that you have on hand all the tools required, or approved equ ivalents The use of RIGHT and LEFT indications in the text, always refers to driving position (when sitting on vehicle)
1Proper streng th Loclile

1Clean inner housing diameter and outer gasket diameter2Spray housing and gasket with LOCTITE PRIMER
N (PIN 293 800 041)
3Apply strip of proper strength Loctite on leading edge of outer metallic gasket diameterNOTE: Any Loctite product can be used here low strength liquid is recommended as normal strength and gap are required 4Instal according to standard procedure5Wipe off surplus 6Allow it to cure for 30 minutesNOTE: Normally used on worn-out housings to prevent leaking or sliding It is generally not necessary to remove gasket compound applied on outer gasket diameter