2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 686Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 686

INTRODUCTION
3Twist bolt when inserting it to improve thread conformation NOTENOT intended for eng ine stud repairs
4Apply LOCTITE 518 (PIN 293 800 038) on both sides of gasket, using clean applicator5Place gasket on mating surfaces and assemb le immediatelyNOTE: If the cover is bolted to bl ind holes (above)apply proper strength Loctite in the hole and on threads Tighten holes are sunken, apply proper strength Loctite on bolt threads Tighten as usual
Repair of Small HolesFine Threads
Option 1: Enlarge damaged hole, then follow STANDARD THREAD REPAIR procedu reOption 2: Apply FO RM-A-THREAD on the screw and insert in damaged hole
Permanent Stud Installation (light duty)
1Use stud or thread on desired length 2DO NOT apply release agent on stud 3Do STANDAR THREAD REPA IR 4Allow to cure for 30 minutes5Assemble
MOUNTING ON SHAFT
Mounting with Press

GASKET COMPOUND
-''AUUA3l)A