2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 685Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 685

INTRODUCTION
3Put or drops of proper strength Loctite threadlocker on female threads and in hole NOTE: To avoid hydro lock situation, do not apply too much Loctite
Adjusting Screw

4Apply several drops of prope strength Loctite on stud threads 5Install stud 6Install cover, etc 7Apply drops of proper strength Loctite on uncovered threads 8lighten nuts as required
Pre-Assembled Parts
1Apply here 2Plunger

1Adjust scre to proper setting 2Apply drops of proper strength Loctite threadlocker on screwbody contact surfaces 3Avoid touching metal with tip of flask NOTE: If it is difficult to readjust, heat screw ith soldering iron (232 (450F))
STRIPPED THREAD REPAIR