2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 684Get this manual

2009-2010 Ski-Doo REV-XP/XR 2 Stroke and REV-XR 1200 4-TEC Service Manual, Page 684

INTRODUCTION
SELF-LOCKING FASTENERS PROCEDURE

4Fit bolt in the hole 5Apply few drops of threadlocker at proposed tightened nut engagement area6Position nut and tighten as requ ired
Blind Holes

OOAIlLA

TYPICAL -

SELF-LOCKING FASTENER

The following describes the most common application procedures when working with self-locking fasteners Use metal brush or tap to clean the hole properly then use solventlet act during 30 minutes and ipe offThe solvent utilization is to ensure the adhesive works properly
APPLICATION PROCEDURE
The fol lowing describes the most commo application procedures when working with Loctite products NOTE: Always use proper strength Loctite product as recommended in this Shop Manual