2006 Ski Doo REV Service Shop Manual, Page 483Get this manual
Section 12 TECHNICAL DATA Subsection 03 (LIQUID COOLED (SDI) MODELS)
TECHNICAL DATA LEGEND
BTDC: CDI: MAG: N.A PN: PTO: R.A.S RER: RPM: TRA: VSA: W: Before Top Dead Center Capacitor Discharge Ignition Magneto Not Applicable Part Number Power Take Off Response Angle Suspension Rotax Electronic Reverse Revolution Per Minute Total Range Adjustable Variable Sheave Angle Watt (1) The maximum horsepower RPM applicable on the vehicleIt may be different under certain circumstances and BRP reserves the right to modify it without obligation(2) Crankshaft end-play is not adjustable on these modelsSpecification is given for verification purposes only(3) At 3500 RPM with headlamp turned on(4) All resistance measurements must be performed with parts at room temperature (approx20C (68F))Temperature greatly affects resistance measurements(5) Drive pulley retaining screw: torque to 80 to 100 Nm (59 to 74 lbfft), install drive belt, accelerate the vehicle at low speed (maximum 30 kmh (20 MPH)) and apply the brake; repeat timesRetorque screw to 90 to 100 Nm (66 to 74 lbfft)(6) CAUTION: Do not attempt to adjust gap on spark plug BR ECSThe specification is given for verification purpose onlyIf found out of specification, replace with new one(7) 793 HO Power TEK: with TPS (Throttle positioning Sensor) disconnected995 SDI: with APS (Air pressure Sensor) disconnected(8) Force applied midway between pulleys to obtain specified tension deflection(9) Force or downward pull applied to track to obtain specified tension deflection(10) Minimum allowable width may not be less than 3.0 mm (18 in) of new drive belt