2006 Ski Doo REV Service Shop Manual, Page 461Get this manual
Section 11 BODYFRAME Subsection 01 (BODY)
INSTALLATION AND ADJUSTMENT DECAL
To remove decal; heat old decal with heat gun and peel off slowlyUsing isopropyl alcohol, clean the surface and dry thoroughlyApply liquid soap to new decal and carefully position the decalUsing sponge or squeegee, remove the air bubbles and surplus water working from the center toward the edgesAllow to air dryCAUTION: Do not apply isopropyl alcohol or solvent directly on decalsUse only in well ventilated area
A32H49A
1Grommets
WINDSHIELD
Pull windshield one side at time as shown to remove it
Position the windshield on the windshield supports then push it down until the pins are fully inserted into the grommets