2006 Ski Doo REV Service Shop Manual, Page 363Get this manual
Section 08 DRIVE SYSTEM Subsection 05 (BRAKE)
Install the Banjo bolt no7 with two new sealing rings no8Fasten caliper on chaincaseDo not forget to install and fold locking tab over caliper boltFill the brake system and bleed itRefer to BLEEDING at the end of this sectionThe brake disc no10 must be centered in caliperApply brake then check for proper brake disc positioningPush on appropriate caliper piston in order to move pad inward allowing proper brake disc positioning
A30D1BA
A1 mm (132 in) minimum
Removal
Brake pads removal procedure is as follows: Remove retainers no12 from the pins no13 Pull out the pins which releases the spring no142