2006 Ski Doo REV Service Shop Manual, Page 355Get this manual
Section 08 DRIVE SYSTEM Subsection 03 (DRIVEN PULLEY)
Install slider shoes as per following photoRed slider shoes are being used for reverse and black ones for forward
ADJUSTMENT
Make sure to install proper cam no11Refer to TECHNICAL DATACam angle is identified on cam
A30D0WA
1BLACK slider shoe 2RED slider shoe
Screws no12 are machined at their endWith the adjustment ring steel to position (zero), screw ends are flush with inner side of fixed pulley half when tightenCAUTION: If any of these screws is not flush with inner side of sliding pulley, bushings will worn unequallyAssemble driven pulley components by reversing the disassembly procedure