2006 Ski Doo REV Service Shop Manual, Page 345Get this manual
Section 08 DRIVE SYSTEM Subsection 02 (DRIVE PULLEY)
Use the drive pulley holder (PN 529 035 674)See removal procedureTorque screw to 90 Nm (66 lbfft)Install drive belt and guardRaise and block the rear of the vehicle and support it with mechanical stand
WARNING
Ensure that the track is free of particles which could be thrown out while track is rotatingKeep hands, tools, feet and clothing clear of trackEnsure nobody is standing near the vehicleA16D0EA
TYPICAL 1Align
Carefully slide governor cup into sliding halfAlign mark of governor cup with mark of fixed halfRemove forks and push governor cup so that its splines engage with fixed half shaft splines
Accelerate the vehicle at low speed (maximum 30 kmh (20 MPH)) and apply the brake, repeat timesRetorque screw to 95 Nm (70 lbfft)
WARNING