2006 Ski Doo REV Service Shop Manual, Page 343Get this manual
Section 08 DRIVE SYSTEM Subsection 02 (DRIVE PULLEY)
Lever, Nut and Cotter Pin
NOTE: While installing lever no29 make sure that the curved sides of the levers are outwards as shown
593 HOSDI Engine Equipped Models Only
A32D1ZA
Always install lever assemblies so that cotter pins no30 are on the shown sideBesides install cotter pin head on top when lever is sat at bottom of sliding halfBend cotter pin ends to sit perfectly against lever
A32D1XA
1Head on top 2All on the same side
WARNING