2006 Ski Doo REV Service Shop Manual, Page 340Get this manual
Section 08 DRIVE SYSTEM Subsection 02 (DRIVE PULLEY)
Check lever bolts no19 for wear, replace as required
O-ring and Slider Shoe
Check if O-rings no20 are cracked, cut or crushedReplace as requiredCheck slider shoes no9 for wearReplace if groove is not apparent on top
Fixed Half and Governor Cup
Inspect splines and free play between both partsMaximum free play is 0.5 mm (.020 in) measured at calibration screw radiusReplace if required
529 031 200 529 035 524
Sliding Half and Spring Cover Bushings
Visually inspect coating of bushings no14 and no15Replace if wornSliding Half Bushing Replacement NOTE: In case of worn out bushing, it is advisable to replace whole sliding half assembly as replacing just the bushing may reduce the drive pulley performanceRemove circlip no21 from the sliding halfA32D2UA