2006 Ski Doo REV Service Shop Manual, Page 238Get this manual
Section 05 ENGINE MANAGEMENT (POWER TEK) Subsection 03 (COMPONENT INSPECTION, REPLACEMENT AND ADJUSTMENT)
E-RAVE SOLENOID
If the solenoid does not work, disconnect the connector from the solenoidMeasure voltage between pin (on harness side) and battery ground (engine ground on manual start models)If 12 is read, disconnect connector from the ECM and check continuity of circuit between pin DA-13 and pin 1If continuity tests good, try new ECMRefer to ECM for replacement proceduresIf 12 is not read, check the corresponding fuse(s), relay and continuity of circuit V-2If continuity is faulty, repair wiringconnector
Heating Element
Unplug the 2-pin connector located besides E-RAVEMeasure voltage between REDYELLOW and BLACK wires of heating elementIf 12 is read, check BLACK wire circuitIf good, replace E-RAVE solenoidIf 12 is not read, check the corresponding fuse(s), relay and continuity of circuits VH-1 and VH-2If continuity is faulty, repair wiringconnector