2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 528Get this manual
Section 10 STEERINGFRONT SUSPENSION Subsection 01 (STEERING SYSTEM)
The ball joint should be restrained when tightening the tie rod end lock nutAlign it so the tie rod end is parallel to the steering arm when assembled on the vehicle, refer to the following illustrationFor proper torque specifications refer to the specific exploded view for the vehicle being serviced1 2
17, Steering Arm
Tundra Steering arm notch must face outside of vehicle
A02G0IA
TYPICAL 1Parallel with steering arm 2Steering arm
A05G0CB
WARNING
The cut off section of the ball joint must run parallel with the steering armWhen tightening lock nuts, restrain ball joint with appropriate size wrenchThe maximum external threaded length not engaged in the tie rod must not exceed 20 mm (2532 in)