2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 515Get this manual
Section 09 REAR SUSPENSION Subsection 04 (DRIVE AXLE)
Install chaincase and position seals (if applicable), making sure that gap of approximately mm (116 in) exists between end of bearing housing and each seal3 2
A00F0GA
A33D0OA
TYPICAL ALL MODELS EXCEPT TUNDRA
SIDE VIEW 1Bearing 2Seal 3Housing 4Seal lip A2 mm (.080 in) approximately
The bearing on the splined side of axle must be pushed until it is seated on shaft shoulderThe end bearing housing bearing must be flush with end of drive axleEach bearing must have its shield facing the sprocket1 1
3, Retainer Ring