2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 502Get this manual
Section 09 REAR SUSPENSION Subsection 03 (SUV SUSPENSION)
REMOVAL
Release track tensionLift rear of vehicle and support it off the groundUnbolt front arm then rear arm
Self-Locking Screws
CAUTION: These self-locking screws must always be replaced by new ones every time they are removedNOTE: To prevent axle from turning when unscrewing self-locking screws, proceed as follows: Remove one self-locking screw then install 10 mm shorter non-self-locking one in placeTorque as specified in exploded view Remove the opposite self-locking screw Remove the temporary installed non-self-locking screw If it doesn't work, heat bolt head to melt threadlockerRemove suspension assembly