2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 492Get this manual
Section 09 REAR SUSPENSION Subsection 01 (TORQUE REACTION SUSPENSION)
7,8, Support and Front Arm Support
To remove rivets securing the supports, cut rivet heads off using cold chiselAt assembly, position the rivet head toward the outside of the assemblySupport the rivet head against metal block, as shown, and use flat head punch to secure the rivet in place
A03F3SA
TYPICAL 1Slider shoe 2Molding line (wear limit indicator)
Replace slider shoes when wear limit is reached4
A07F02A
CAUTION: Slider shoes must always be replaced in pairs
Flat head punch Support Runner Metal block