2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 481Get this manual
Section 08 ELECTRICAL Subsection 06 (TESTING PROCEDURE)
Connect multimeter probes to WHITEBLUE and BLACK wires coming out from modulePlace the selector switch to Vac and the scale to 00.0
Voltage Testing Disconnect spark plug cap from spark plug Fasten alligator clip to spark plug cable, near the spark plug Connect other multimeter wire to engine (ground), then place selector switch to Vac and scale to 0.001 2
A32E0ZA
TYPICAL
Activate the manual starter and check values indicated by the multimeter Repeat operation times Compare readings with those appearing in the IGNITION table
A32E11A
1MAG side spark plug cable 2Connected to ground