2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 464Get this manual
Section 08 ELECTRICAL Subsection 05 (ELECTRIC STARTER)
A19E0BA
A19E01A
Twist screwdriver to separate stop collars no12 thus giving access to circlip no13Remove outer collar, circlip then inner collarRemove overrunning clutch no11Check the wear on bushing no18 by measuring the amount of radial play between the armature shaft and the bushingThe radial play should not exceed 0.20 mm (.008 in)If greater, replace the bushingTo replace, press out the old one toward bushing cover and press in new one with bushing pusherThe correct size of the bushing pusher to use is given on next illustrationCAUTION: Support drive housing adequately to prevent damage when pressing bushingA B