2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 439Get this manual

2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 439

Section 08 ELECTRICAL Subsection 01 (IGNITION TIMING)
"0" now indicates exact TDC Rotate the drive pulley clockwise, one-quarter turn then carefully rotate it counterclockwise until the needle indicates the specified measurement, indicated in TECHNICAL DATA Twist wire as shown and use it as pointerInstall the wire on upper starter bolt
A29E0TA

TYPICAL 1Timing mark in line with pointer end

Checking Ignition Timing
A29E0RA

TYPICAL 1Pointer

Use timing lightTo check the ignition timing, refer to illustration and proceed as follows:

Back to 2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual