2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 388Get this manual
Section 07 TRANSMISSION Subsection 03 (DRIVEN PULLEY)
A07E0CA
TYPICAL 1Belt flush with the top of the pulley halves
A05D12A
1Adjusting hole
Insert other spring end in camMount driven pulley spring compressor (PN 529 035 300) as in DISASSEMBLY procedurePush cam all the way in then install roll pin coated with anti-seize lubricant (PN 413 701 000)
Shim(s) no11 and no12 provide belt height adjustment between pulley halvesAdding shims will lower the belt in driven pulley, while removing shims will raise the beltAdjust properly
Pulley Alignment and Drive Belt Deflection