2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 379Get this manual
Section 07 TRANSMISSION Subsection 02 (DRIVE PULLEY)
5,6,18,19, Fixed Half, Sliding Half, Spring, Spring Cover and Screw
To install spring cover, use pulley spring compressor (PN 529 035 524)Assemble fixed and sliding halvesNote that fixed halves have different cone angleMatch cone angle with crankshaftLift sliding half against spring cover and align spring cover arrow with sliding half mark
CAUTION: Make sure O-rings are installed on slider shoes and that grooves are positioned verticallyInstall fork (PN 529 005 500) into slider shoe grooves to maintain them for governor cup installationProceed on set of slider shoes
529 005 500
A16B02A
TYPICAL
Make sure to align governor cup arrow with sliding half and fixed half markTRA III NOTE: If fixed half has no mark, align governor cup mark with segment no1 of inner halfSegments are identified on engine sideA32D1YA