2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 378Get this manual

Section 07 TRANSMISSION Subsection 02 (DRIVE PULLEY)
9,11,13,14, Screw, Lever Ass'y, Nut and Cotter Pin
TRA III and IV NOTE: While installing lever assemblies make sure that the curved sides of the levers are outwards as shown
A32D1XA

A32D1ZA

1Head on top 2All on the same side

All Models Always install lever assemblies so that cotter pins are on the shown sideBesides install cotter pin head on top when lever is sat at bottom of sliding halfBend cotter pin ends to sit perfectly against lever

• ATV
• Jet Ski
• Outboard Motors
• Personal Watercraft
• Snowmobiles
• Stern Drives