2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 377Get this manual
Section 07 TRANSMISSION Subsection 02 (DRIVE PULLEY)
Spring Cover Bushing Replacement Under normal use there is no need to replace this bushingIn case of replacement, it's recommended to replace spring cover ass'yA16D08A
ASSEMBLY
NOTE: This drive pulley is lubrication freeDo not lubricate any component
1Chamfered side
Position dowel tube split at the angle AA
1,2,3, Screw, Ring Gear and Loctite 271
Apply Loctite 271 (PN 293 800 005) on threads and then torque to 27 Nm (20 lbfft)
26,27,28, Calibration Screw, Washer and Locking Nut
When installing calibration screw, make sure to install washer as shown1