2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 376Get this manual
Section 07 TRANSMISSION Subsection 02 (DRIVE PULLEY)
A32D2VA A32D2XA
Use soft sand paper to clean sliding half bushing mounting surface
NOTE: Make sure that the bushing is well seated on the sliding half ass'yA32D2WA A32D2YA
Clean sliding half bushing mounting surface with pulley flange cleaner (PN 413 711 809)To install new bushing, secure the pulley spring compressor (PN 529 035 524) in vise and mount the sliding half ass'yInsert the bushing from inner side of sliding half ass'yMount the large bushing extractor tool (PN 529 035 931) with side marked "IN" to press in new bushing