2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 367Get this manual
Section 07 TRANSMISSION Subsection 02 (DRIVE PULLEY)
529 006 400
1 529 025 000
A29D23A
Remove driven pulley to make room for drive pulley removalRemove drive pulley
DISASSEMBLY
Skandic LT Only Remove retaining screws no17 and washers no18 from ring gear no19CAUTION: Retaining screws must be heated before disassemblyHeating temperature must not exceed 150C (300F)Skandic LT and Skandic LT Mount tapered tool (PN 529 035 826) in viseInstall drive pulley over retainer then, fasten retaining screw no1 and torque to 68 Nm (50 lbfft)Now drive pulley is locked on retainerScribe pen marks on fixed half no16, sliding half no10, spider no5 and cover no3 for proper indexing at reassemblyA29D24A