2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 343Get this manual
Section 06 ENGINE MANAGEMENT (4-TEC) Subsection 03 (COMPONENT INSPECTION AND ADJUSTMENT)
Connect the CPS, CTS and OPS to the wiring harnessNOTE: Routing of the harness for CAPS, CTS and OPS has to be between the intake manifold and cylinder 1, underneath the water hosesUse locking ties to attach the cables for the CTS on the water hose and on the sensor itself then for the OPS on the T-fitting and on the sensor itself
R1004motr157A
1Throttle position sensor (TPS)
IMPORTANT: Prior to testing the TPS, ensure that mechanical componentsadjustments are adequate according to THROTTLE BODY in AIR INDUCTION SYSTEM aboveThe EMS may generate several fault codes pertaining to the TPSRefer to SYSTEM FAULT CODES in DIAGNOSTIC PROCEDURES section for more information
Wear Test
R1004motr182A
1Locking ties