2005 Ski-Doo Tundra, Skandic, Expedition Shop Manual, Page 332Get this manual
Section 06 ENGINE MANAGEMENT (4-TEC) Subsection 03 (COMPONENT INSPECTION AND ADJUSTMENT)
The only thing that has to be performed when the throttle body has been replaced is the Closed Throttle and Idle Actuator resetRefer to THROTTLE POSITION SENSOR (TPS) in ELECTRONIC MANAGEMENT belowThrottle Cable Adjustment Mechanically adjust the throttle cableHandlebar and throttle cable must be at their normal positionApply full throttlePull on throttle cable housing with force of 50 (11 lbf)Tighten top nut to Nm (9 lbfin)Tighten bottom nut to 4.5 Nm (40 lbfin)
Closed Throttle and Idle Actuator Reset Perform the Closed Throttle and Idle Actuator reset as described in THROTTLE POSITION SENSOR (TPS) in ELECTRONIC MANAGEMENT below